Before you start programming your RRL Network, decide if you are going to configure and start all of your hardware in the office, or out in the field. Our recommended method is to set all hardware up in the office to ensure the RRL Stations and connected Leveloggers are communicating as programmed, before installation. However, you must remember to keep a record of each RRL Station and the position and serial numbers of each connected Levelogger, to ensure, when in the field, you connect all hardware as programmed.
This guide will take you through the recommended steps to set up your RRL Network.
Note:
RRL Networks can bridge with an STS Edge Telemetry System. See STS Edge User Guide.
