The Vented Cable ends terminate with female twist connections for the LevelVent 5 or AquaVent 5 logger and the Wellheads. Therefore, the Vented Cables are interchangeable (i.e. it does not matter which end is installed on the Wellhead or logger).
For diagnostic purposes, you may wish to install the end of the Vented Cable with the serial number, to the Wellhead connection at surface.
126.96.36.199 Connecting to the LevelVent Wellhead
Remove the storage caps from the connectors on the Wellhead and Vented Cable.
Ensure you save all the storage caps for future use.
Line up the alignment pin and socket.
Gently push the Wellhead and Vented Cable together and twist slightly until you hear/feel a small click when the properly aligned connection is made.
Only tighten the stainless steel coupling while holding the Vented Cable and Wellhead still. Tighten the coupling until it seats. Do not twist the Vented Cable or Wellhead.
Figure 1-11 Connecting a Vented Cable to the LevelVent Wellhead
Do not twist the Vented Cable when connecting to a Wellhead or LevelVent logger. Only turn the stainless steel coupling.