1.0 Introduction
2.0 AquaVent Independent Recording Option
3.0 AquaVent SDI-12 Setup
4.0 Aquavent SDI-12 Operation
- 4.1 The SDI-12 Address
- 4.2 Activation and Verification
- 4.3 Changing or Updating AquaVent Loggers
- 4.4 Changing SPX Wellhead Batteries
- 4.5 AquaVent Firmware Upgrades
5.0 SDI-12 Supported Commands
- 5.1 Acknowledge Active Command: a!
- 5.2 Address Query Command: ?!
- 5.3 Send Identification Command: aI!
- 5.4 Change Address Command: aAb!
- 5.5 Start Measurement Command: aM!
- 5.6 Start Measurement Command with Checksum: aMC!
- 5.7 Send Data Command: aD0!
- 5.8 Start Concurrent Measurement Command: aC!
- 5.9 Start Concurrent Measurement with Checksum: aCC!
- 5.10 Start Verification Command: aV!
6.0 Troubleshooting
7.0 References
