Table of Contents

3-Channel CMT Assembly

• CMT Multilevel System Pre-installation Requirements

  • Minimum information required for effective design of the CMT Multilevel System
  • Ensure that these additional items are available on site during installation

• Introduction

• Preparation

• Assembling Standard CMT Multilevel Systems

• Marking and Cutting the Tubing

  • Step 1) Uncoil Tubing
  • Step 2) Indicate Ground Surface on Tubing
  • Step 3) Locate Channel 1 Identifier
  • Step 4) Mark Monitoring Port 1
  • Step 5) Mark Port 1 for Port Cutting Guide
  • Step 6) Mark all Ports and Cut Tubing at Deepest Port
  • Step 7) Complete Design



• Cutting the Outer Ports and Vent Holes

  • Step 8) Install the Port Cutting Guide
  • Step 9) Use Cutting Bolts to Cut Holes
  • Step 10) Cut Panel Between Upper Two Port Holes
  • Step 11) Insert Expansion Plug
  • Step 12) Install the Well Screen
  • Installing Oetiker Clamps
  • Step 13) Line-up Port Cutting Guide
  • Step 14) Create Port 2 Opening
  • Step 15) Finish Constructing Port 2
  • Step 16) Construct Port 3



• Configuring the Bottom of the CMT Tubing (Zone 7)

  • Step 17) Insert Expansion Plugs
  • Step 18) Attach the Guide Point Port



• CMT Placement

  • Step 19) Lower the CMT System
  • Step 20) Complete the Well Installation
  • Step 21) Attach the Wellhead

CMT Installation with Sand and Bentonite Cartridges

• Introduction
• Installation Design Example
• Preparation
• Installation
• Port Assembly
• Installing Sand Cartridges
• Installing Spring Cartridges

Monitoring Options

• Water Level Measurement
• Well Completion
• Sampling Methods

Terms and Conditions