CMT Assembly Manual Table of Contents

CMT Multilevel System Pre-installation Requirements

• Minimum information required for effective design of the CMT Multilevel System
• Ensure that these additional items are available on site during installation

Introduction

Preparation

Assembling Standard CMT Multilevel Systems

• Marking and Cutting the Tubing

  • Step 1) Uncoil Tubing
  • Step 2) Indicate Ground Surface on Tubing
  • Step 3) Locate Channel 1 Identifier
  • Step 4) Mark Monitoring Port 1
  • Step 5) Mark Port 1 for Port Cutting Guide
  • Step 6) Mark all Ports and Cut Tubing at Deepest Port
  • Step 7) Complete Design

• Cutting the Outer Ports and Vent Holes

  • Step 8) Install the Port Cutting Guide
  • Step 9) Use Cutting Bolts to Cut Holes
  • Step 10) Cut Panel Between Upper Two Port Holes
  • Step 11) Insert Expansion Plug
  • Step 12) Install the Well Screen
    • Installing Oetiker Clamps
  • Step 13) Line-up Port Cutting Guide
  • Step 14) Create Port 2 Opening
  • Step 15) Finish Constructing Port 2
  • Step 16) Construct Ports 3 to 6

• Configuring the Bottom of the CMT Tubing (Zone 7)

  • Step 17) Insert Expansion Plugs
  • Step 18) Attach the Guide Point Port
  • Step 19) Install an Anchor

• Attaching Tubing Centralizers

  • Step 20) Install Centralizers

• CMT Placement

  • Step 21) Lower the CMT System
  • Step 22) Complete the Well Installation

• Attaching the Standard Wellhead

  • Step 23) Attach the Wellhead

Optional Flow Control Monitoring Assembly

Monitoring Options

• Water Level Measurement
• Well Completion
• Sampling Methods

CMT Specifications & Considerations

Terms and Conditions