3.3.2 Setting Up Levelogger Measurement Parameters

In the lower portion of the Levelogger Information screen is the window for setting channel parameters. The software will detect the available channels when the Levelogger Information settings are read.

 

The Level Channel

 

The Temperature Channel

Note:

The Levelogger Junior, LTC Levelogger Junior, Levelogger Gold and Barologger Gold only measure in °C.

solinst sts telemetry system sts administrator sts administrator screen image

Figure 3-6 Temperature Channel

 

After filling out the required fields, click Save Settings to apply the information. The Levelogger Setup window will again be shown.

Continue entering information for each of the attached Leveloggers. When each datalogger has been programmed, click Next on the Levelogger Setup window. The Alarms Setup window will open.

 

LTC Levelogger Junior Measurement Parameters

solinst sts telemetry system sts administrator sts administrator screen image

solinst sts telemetry system sts administrator sts administrator screen image

Figure 3-7 LTC Levelogger Junior Settings


After filling out the required fields, click Save Settings to apply the information. The Levelogger Setup window will again be shown. Continue entering information for each of the attached Leveloggers. When each datalogger has been programmed, click Next on the Levelogger Setup window. The Alarms Setup window will open.

 

Rainlogger Measurement Parameters

Note:

Your Rainlogger Edge must be using firmware version 3.000, and Ranlogger firmware must be upgraded to 2.000 or higher.

There is one channel of measurement for Rainloggers. The ‘RainFall’ Channel records each tip time by the connected tipping-bucket and outputs the amount of rainfall per tip (input Rainfall Cal Constant). When an STS Gold Controller reports Rainlogger data to the Home Station, it will send the accumulated rainfall amount per sample period (based on STS Gold Controller Sample Rate). To determine the exact time that a tip occurred, the Rainlogger would have to be set to record in its own internal memory, which stores each tip event.

Note:

The Sample Rate and Max Rainfall options included in Rainlogger firmware versions previous to 2.000, are no longer available.

solinst sts telemetry system sts administrator sts administrator screen image

Figure 3-8 Rainlogger Settings

Note:

When an STS Gold Controller reports Rainlogger data to the Home Station, it will send the accumulated rainfall per sample period (based on STS Gold Controller Sample Rate).


After filling out the required fields, click Save Settings to apply the information. The Levelogger Setup window will again be shown.

Continue entering information for each of the attached Leveloggers. When each datalogger has been programmed, click Next on the Levelogger Setup window. The Alarms Setup window will open.