Table of Contents

Narrow CMT Multilevel System Assembly Manual

• CMT Multilevel System Pre-installation Requirements

• Introduction

• Preparation

• Assembling Standard CMT Multilevel Systems

• Marking the CMT Tubing

  • Step 1) Uncoil Tubing
  • Step 2) Indicate Ground Surface on Tubing
  • Step 3) Locate Channel 1 Identifier
  • Step 4) Mark Monitoring Port 1
  • Step 5) Mark Port 1 for Port Cutting Guide
  • Step 6) Mark all Ports and Cut Tubing at Deepest Port
  • Step 7) Complete Design

• Cutting the Ports and Vent Holes

  • Step 8) Install the Port Cutting Guide
  • Step 9) Use Cutting Bolts to Cut Holes
  • Step 10) Cut Panel Between Upper Two Port Holes
  • Step 11) Insert Expansion Plug
  • Step 12) Install the Well Screen
  • Installing Oetiker Clamps
  • Step 13) Line-up Port Cutting Guide
  • Step 14) Create Port 2 Opening
  • Step 15) Finish Constructing Port 2
  • Step 16) Construct Port 3

• Configuring the Bottom of the CMT Tubing (Zone 7)

  • Step 17) Insert Expansion Plugs
  • Step 18) Attach the Guide Point Port

• Narrow CMT Placement

  • Step 19) Lower the CMT System
  • Step 20) Complete the Well Installation
  • Step 21) Attach the Wellhead

• CMT Installation with Sand and Bentonite Cartridges

  • Introduction
  • Installation Design Example
  • Preparation
  • Installation
  • Narrow CMT Port Assembly
  • Installing Narrow CMT Sand Cartridges
  • Installing Narrow CMT Spring Cartridges

• CMT Multilevel System Monitoring Options

  • Water Level Measurement
  • Well Completion
  • Sampling Methods

• Terms and Conditions